Click on the image to check the artwork
LFT mould(long fiber thermoplastics)
LFT is bulk molding material that feature continuous fiber filaments running the full length of the pellet allowing these materials to exhibit simultaneous improvements in strength,stiffness,and impact resistance over a wide temperature range.
D-LFT(Direct-long fiber thermoplastics is avaliable for injection or compression molding. Most D-LFT systems,for injection or ocmpression molding system,feed glass rovng (or other fiber)into a twin-screw extruder(TSE),where it is chopped by the screws as it is mixed with molten polymer and additives that have been metered in separately. To improve surface finish,some systems use knives to prechop the roving prior to entrance into the TSE. This method generally yields a shorter fiber,while the direct roving feed produces longer fibers and yields parts with higher structural performance. Each approach uses different and specialized screw designs.
Established in 2006, Jie Mei Group is your trusted source for the dlft composite material for housing under the car made in China as one of the leading manufacturers and suppliers of various moulds. And we're also equipped with a professional factory at your service.